Sunday, July 11, 2021

Prepping to weld up the dropped transmission mount

My main work on the car today was working on my welding. I've been having a nagging problem with my welder not feeding wire smoothly, so today I tinkered with that some. I replaced the contact tip, made sure the drive rollers were set up correctly and working well... and then noticed that the spool of wire was tangled somehow. I ended up chucking out maybe half a pound of wire and just putting a fresh spool on.

In addition to that, though, I've been getting ready to weld up the dropped transmission mount. This is from the rear of the frame, looking forward. The chunk of frame that I cut out is bolted to the transmission; you can see the three inch drop, which should go a very long way toward solving the oiling problem.

Here are the drop tabs all marked for shaping. I could easily use them without any addition trimming, but those extra bits would bug me. And I have grinders!
Now, with the engine and transmission pulled out again, here is a look at the right-rear drop tab, clamped up to the frame.

I am going to work on fitting up the subframe between the tabs - it needs a little strategic grinding to fit. Then, with the frame bolted to the transmission, and the engine in the car, I will tack the tabs to the subframe. After that, I will unbolt the subframe and fully weld that up on the bench.

The hard part then will be welding the whole thing up to the frame.
 

No comments:

Post a Comment